Bolt Factory Introduces The Whole Process Of Screw Production


  Every industry has its own assembly lines and rules t […]

  Every industry has its own assembly lines and rules that belongs to each industry. In this society, I think that each industry must communicate more and understand each other’s production procedures so that social harmony can be promoted. Be considerate of each other, understand each other's work responsibilities, and popularize the knowledge interface of different industries, so that everyone's thinking is no longer limited to their own majors.

  So now the bolt factory will let everyone know what the whole process of screw production is. Let everyone know that mechanical production is a very cautious process, and the responsibility to bear is also very heavy, not even a small screw. I can ignore that this is respect for life and responsibility for society.

  The first is the coil. According to the requirements in real life, the bolt factory should figure out the factory plate, specifications, material, and product name, as well as the weight and quantity, and then buy some suitable coils. When buying, don’t just choose cheap ones and choose low-quality ones. For your life, everyone should choose high-quality ones.

  The second is annealing, which is to increase the forging capacity of screws so that the post-processing production will be more convenient.

  The third is pickling. Although the link is relatively simple, just do a treatment on the surface of the screw, but this link will make the next link more convenient.

  The fourth is to draw the line, to undertake the above pickling link.

  Fifth, start, this link is to complete the tooth shaping.

  Sixth, heat treatment to change the mechanical properties of the screw.

  Seventh, electroplating, this link is very important in order to meet customer requirements and product beauty.

  These are the whole process of the bolt factory's production of screws. I hope it can help everyone understand the screw production.